Revival of the Free Gear thread

[EWG]

Kids medium mountain hardware rain jacket.
In great shape except that there is some cracking in the lining on the lower part of the hood. Happy to ship, which should be about $5-6. Free, plus any shipping, but if you want to toss in some beer money I wouldn't say no.

CLAIMED

[caulfield]

couple liners for cost of ship, or pickup in seattle

stock liner from 27.5 backland carbon (2020 I think, the boa model). 40ish days on them, baked at least once

stock liner from 27.5 hawx xtd 130, prime last (2021? model, the gray one). ~20 days on these ones, baked once--these are gone

[scmartin69]

Scarpa Freedom SL 28.0
Both sets of sole plates, tours look to be almost unused
Free plus actual shipping from 89511


Sent from my SM-S906U using Tapatalk

[EWG]

Therm-ic battery package.

- A pair of used heating elements. I believe they still work but wouldn't swear it on a copy of Aspen Extreme.
- A pair of Supermax Plus batteries. Unmodified and they work fine, but I think the battery life has gotten shorter.
- A pair of Powerpack Max batteries. I took these apart and replaced the battery cells inside. They are a little ugly but they work great and have quite a bit of power. However, there is a connection inside one of them that tends to disconnect when they get cold, so one of these probably should be pulled back apart and reconnected. Not sure which part is the problem, as I haven't taken them apart to look. Homemade modification, so use at your own risk.
- A single disassembled battery with a replacement set of battery cells that has broken apart. You aren't supposed to connect metal to batteries with a normal soldiering iron because the heat can hurt the performance of the battery and the battery can also explode from the heat, so I ditched this repair.
- Two chargers. Both have a fraying wire that is causing it to lose power, but they are in different places so one could easily use the good parts of both chargers and splice them together to make a solid one.

If you don't know what you are doing with electronics and electricity this not a good setup for you to grab and you should pass. And anything anyone does with these is at their own risk.

Beer money gets you an afternoon project and warm feet. You pay shipping if you aren't local to the front range.

[whyturn]

I have like 5 pairs of gap jeans
Black, light wash blue and dress blue
All are 36/34 and in great condition

Prefer SLC ideally Layton but will ship on your dime




Sent from my iPhone using TGR Forums




Lifeproof iPhone X case

[Shorty_J]

I really didn't want to ship these but I offered them locally and no takers.... would rather they get used.

Warden demo 13, 130mm brake, well loved and very scuffed but on the 1 day I skied these I did not die.

PayPal or interac (for canadians), you pay shipping from Calgary Canafa, and I like beer if you feel like a tip.

Sent from my SM-A536W using Tapatalk

[Shorty_J]

^^^ where the fuck is Canafa?

Sent from my SM-A536W using Tapatalk

[scmartin69]

Scarpa Freedom SL 28.0
Both sets of sole plates, tours look to be almost unused
Free plus actual shipping from 89511


Sent from my SM-S906U using Tapatalk

317mm BSL, not sure what that is in Canafa dollars...

Sent from my SM-S906U using Tapatalk

[jhyatt]

Old Telemark stuff in New england
I think the boots are 28.5 but I need to check. No liners.

[406]

Some old Praxis Freerides:
https://www.tetongravity.com/forums/...raxis-Freeride

[charlesj]

Head SL 165 previously drilled for a plate, and some kind of telemark. Can hand them off somewhere in New York State or New England or I guess I can ship them too

[scmartin69]

Scarpa Freedom SL 28.0
Both sets of sole plates, tours look to be almost unused
Free plus actual shipping from 89511


Sent from my SM-S906U using Tapatalk

Scarpas gone...

[charlesj]

Tyrolia Attack2 demo brakes 95mm

(They slide on with the heels)


Sent from my iPhone using TGR Forums

[SchralphMacchio]

Anyone have any use for Binding Freedom MarkerFit swap plates? I don't have all the specs but I think they work with pre-EPF Dukes/Barons/F10-12, Dynafit Radicals, and Marker Royal. I only ever used with with Barons so I can't confirm. Presumably you would use the DynaDuke tempate on the BF webpage to install, but probably worth a test mount first. I may have some various screws that I could send with as well depending on what's needed, but that's TBD. Bought these about 10 years ago.

[ACH]

Anyone have any use for Binding Freedom MarkerFit swap plates? I don't have all the specs but I think they work with pre-EPF Dukes/Barons/F10-12, Dynafit Radicals, and Marker Royal. I only ever used with with Barons so I can't confirm. Presumably you would use the DynaDuke tempate on the BF webpage to install, but probably worth a test mount first. I may have some various screws that I could send with as well depending on what's needed, but that's TBD. Bought these about 10 years ago.

I'll take them.

[NW_SKIER]

I'll take them.

Checks out.

[waveshello]

Rossignol World Cup Radical X FIS 175cm

Free pickup at alpental/Wenatchee or you cover shipping. Bases/edges in great shape. Race plates with pivot mount pattern, one of the forward most toe holes is stripped and will need a heli coil/insert.

[ASmileyFace]

Got a set of Demo Marker Griffon 12s. Non-ID GW toes. No screws, no brakes.

Free + shipping if ya want em.

I guess tap talk has disabled photos so DM for pics if necessary

[whyturn]

Free trek 820 19.5 10 speed twist shift in SLC or Ogden Ideally Layton
Pm for pics in good condition


Sent from my iPhone using TGR Forums

[halliday]

Free to a good home. Stock liners from a pair of Lange XT3 26.5. I wore these for an hour and then put in my old Luxury liners. Not bad liners but not for me.

[m2711c]

those look nice. pm sent.

[halliday]

They're all yours.

[caulfield]

3p tent in Seattle

I have a Sierra Designs Sirius 3 that I got in high school and it's time to pass it on. There's nothing super good about this tent, it's heavy, half of it is single-wall, and the vestibules are almost worthless. But it's also very adequate and served me well until I had the money for a better one. I sealed the seams 4 or 5 years ago and haven't used it much since then, but wouldn't hurt to do it again.

https://www.trailspace.com/gear/sier...igns/sirius-3/

This would be good for someone who doesn't want to lend their nice ultralight tent to their kids (yet). Not worth shipping

[halliday]

Stamps/ beer money. Two pairs of OG SpeedPlay cleats with covers, one set of shims, one set of OG pedals. Cleats are in pretty good shape. Pedals are also in pretty good shape and have been greased religiously. Not a tight and crisp as they used to be but 7 out of ten overall. All screws included.

[SchralphMacchio]

Most of this other than the Enforcers aren't worth the cost of shipping unless you live close or need the thing for spare parts or something. But hey, maybe someone could use this stuff ... if not, it's going on free Craigslist, then garbage. Location is Eugene Oregon if you want to take a wild guess at shipping or pick these up.

Free (+shipping) to established mags ($40 + shipping for JONGs) - 177 Nordica Enforcer (2013), 135-98-125 R19
Bases - Pretty dang good for the age, some minor scratches, no core shots
Edges - Pretty good but may be a bit dull
Topsheet - Old and worn but no significant damage to speak of
2 mounts: threaded inserts for Small Dukes/Barons/F10/F12 (Pre-EPF) @ 305mm on the line, STH2/Warden @ 294mm on the line
These still have life in them, maybe a tad softer and less snappy than when they were new but still just as chickenhead crushingly damp (2 full layers of titanium). I now have 2024 E94s, I liked the feel of these old E98s but the shape eventually got too old school for me. I'm not sure but I think this ski was unchanged from 2008-2014 other than topsheet, I think that makes these the original flat tail Enforcers. Tails are heavily detuned on these to slide through funk snow off piste.





177 Volkl Kendo (2016), 127-90-110
Bases - Serviceable, needs some Ptex, has a welded core shot
Edges - One crack that I have not skied it with. Got these from a mag for free but he may not have noticed the crack, and I never got the time to cut the base out and screw the edge back in place. Too much of a project for me. Otherwise serviceable edges.
Topsheet - Old but no significant damage to speak of
2 mounts: 1 unknown, 1 STH2/Warden @ 295mm BSL I think on the line







179 Line Prophet 100 (2009), 134-100-125
These are really shot skis, chair skis, fence skis ... rock skis at best. Thats what I used them for ... and it shows.
Bases - Somewhere between Fair and Poor?
Edges - I think Fair but haven't looked at them closely in about 10 years
Topsheets - Fair
3 mounts: 2 unknown, 1 Binding Freedom MarkerFit Swap Plate @ 305mm, and don't ask me why but most of the BF plate holes I did with inserts and some I did not. Must have had the wrong drill bit in at the time. And I already gave the plates away to ACH. Like I said, rock skis at best, but maybe someone has a rad creative use for these?





26.5 Black Diamond Method (later Factor 110) (2011), 307 mm BSL
Definitely not worth the cost of shipping whole, but the parts may be? The ski/walk mechanisms on these are pretty worn so there is a lot of "no flex slop" where the cuff is free to rotate without shell elasticity/deformation, then it hits a wall in flex and gets real stiff real fast. But buckles all still work, the AT soles are in good shape as I had replaced those a couple years before I stopped using these, plus I also have color mismatched alpine soles from BD Shivas. I seem to remember that they fit more like a 26 ... for reference I'm now skiing a 25.5 and these were roomy but not outrageously so. Original (extremely packed out) BOA liner and footbeds.