Dynafit Hoji heel fitting alignment?

[ZomblibulaX]

you could also elongate the screw holes in the binding but you may not wana do that

FTR, do not ever do this on any binding. Backing toe screws out, regluing and retightening as mentioned can buy a mm or two at the heel on a misaligned mount, but don't compromise the screw interface, especially on lightweight bindings.

Its not uncommon for that to happen after bootwork, as previously mentioned. The better shops are aware that this can happen and take steps to avoid it from happening when they work on a boot. It can happen with any boot, but lighter/thinner boots are more susceptible.

This. It's a great reminder for bootfitters not to use shortcuts, like throwing a whole boot in an oven to preheat it for a single punch. Like Lindahl said with light boots it's even more important to shield the boot while heating and spot punch precisely. And especially with tech inserts, since metal hardware heats up so much faster than the plastic around it.

[Lindahl]

FTR, do not ever do this on any binding. Backing toe screws out, regluing and retightening as mentioned can buy a mm or two at the heel on a misaligned mount, but don't compromise the screw interface, especially on lightweight bindings.

Agreed. I remember seeing that the Dynafit Superlight toes were already prone to breaking around the screwholes.