Results 1 to 7 of 7
-
03-02-2017, 06:04 PM #1
Set Marker Griffon heel DIN with boot in or out? :/
Trying to review shop setup of new Marker Griffon bindings, and I can't see the DIN setting clearly for the heel when the boot is in. I suspect this is a dumb question, but I always thought you had to set the DIN screws with the boot in?
But there is a height difference between the two parts of the marking line, making it really hard to read at an angle with the boot in. The only way I can get a clear, accurate read is with the boot out.
Further, it looks like the DIN settting drops about 1 point when I put the boot in (as best I can guess looking from the side), so I better be damn sure which way to adjust it.Last edited by carvehard; 03-02-2017 at 06:21 PM.
-
03-02-2017, 06:41 PM #2The JONGiest
- Join Date
- Dec 2016
- Location
- Lamebird
- Posts
- 430
Haha, set it with it out. Make sure you're setting forward pressure correctly
-
03-02-2017, 06:58 PM #3
Thanks, straightline.
I'm thinking now the intended way to do it is with the boot out but the heel piece in the upright position as if the boot is in.
-
03-02-2017, 07:34 PM #4
set DIN with the boot out, set forward pressure with the boot in.
Edit:
For kingpin only, don't forget the lateral release...Last edited by Vinman; 03-02-2017 at 08:39 PM.
fighting gravity on a daily basis
WhiteRoom Skis
Handcrafted in Northern Vermont
www.whiteroomcustomskis.com
-
03-02-2017, 07:38 PM #5
-
03-02-2017, 08:13 PM #6The JONGiest
- Join Date
- Dec 2016
- Location
- Lamebird
- Posts
- 430
Make sure to grease the springs too, wouldn't want them to rust out on yah
-
03-02-2017, 08:38 PM #7fighting gravity on a daily basis
WhiteRoom Skis
Handcrafted in Northern Vermont
www.whiteroomcustomskis.com
Bookmarks