Check Out Our Shop
Results 1 to 4 of 4

Thread: Marker Duke setup??

  1. #1
    Join Date
    Jan 2009
    Location
    Still Searchin
    Posts
    20

    Marker Duke setup??

    Hello all, I'm waiting on a set of G3-Rapid Transits with Marker Dukes and I need to adjust for my boots (335mm), set Forward Pressure, and AFD height.

    Any info would be a major help. Fischer would always give me PDF's on their stuff, but Marker is not like that they wish to have any user pay for service and it's just not needed if you know the tricks and test to run. I assume a simple paper test under the boot would work for the AFD, but on the forward pressure, adjust till some screw or housing lines up with the back of the binding when the boot is forced down? DIN is a no brainer as I’ll set it for my ability, weight, boot size, then back off ¼ and ski and adjust as needed.

    Thanks

  2. #2
    Join Date
    Dec 2007
    Location
    967 tree 4
    Posts
    1,217
    You pretty much summarized it. Fold the instruction paper in two which is the spacing for the AFD. Turn the screw at the rear of the binding for your boot bsl. The top of the screw should be flush with the screw housing. Pretty simple.

  3. #3
    Join Date
    Jun 2006
    Location
    Ventura Highway in the Sunshine
    Posts
    22,445
    Don't know if this is what you are looking for, but take a look. http://www.tetongravity.com/forums/s...d.php?t=116625

    I agree it is a constitutional right for Americans to be assholes...its just too bad that so many take the opportunity...
    iscariot

  4. #4
    Join Date
    Jan 2009
    Location
    Still Searchin
    Posts
    20
    Thanks for the info and the link that will be a help. Sounds liek you just have to play with the FP and get it close as possible.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •