Apologies if this has been covered some where. I love these boots and have been on them for two seasons. Have approximately 80 days on them. I have 5MM lifters (or whatever they are called) on them.
I replaced them once, but lost a couple screw heads when removing/putting new ones on. Is there any process out there to plane the bottoms and put actual rubber soles on them? Or am I just stuck until Solomon comes out with this is boot design in something with a stock rubber sole?
I understand a rubber changes the feel of a boot in your bindings...and this particular boot is made for a certain type of skier and performance that is probably different then me.
I don’t race...I am 190lbs, 5’11” and ski Aspen 40 to 60 days a year and my current everyday ski is a 186 Line Sick Day 104. I primarily ski trees and other ungroomed terrain. I am sure I would be fine in a 120, but I love the lightness of these boots and they fit my foot better then any other boot I have ever tried. The S/Max 120s are heavier and higher volume.
A Lange is too wide in the toe box and my foot is skinny and short. Not sure if that is the right description...but if you know this boot you know it is narrow and low volume vertically. Sorry...NOT a boot fitter.
Thanks for the help!
Sent from my iPhone using TGR Forums
Bookmarks