Tecnica Mach1 Thread

[Shorty_J]

DIY is cheaper and then you can do it for any binding.

Sent from my SM-A536W using Tapatalk

[wilcox510]

Suggestions for material other than cutting boards?

[Shorty_J]

I'm not a plastics expert but if memory serves, HDPE sheet is what I used?

I can buy small samples from a local plastics shop.

Sent from my SM-A536W using Tapatalk

[iriponsnow]

Cold River tools makes ships that are swanky & fit just about every clamp.

[wilcox510]

Anyone tried replacing the T Drive piece with the non carbon version to soften the boot up? My shop recommended that and discouraged removing the top bolt, although the didn't really have a good reason why..

https://www.blizzard-tecnica.com/us/...-t-drive-piece

[wilcox510]

Cold River tools makes ships that are swanky & fit just about every clamp.

Thanks for the info!!

[mr_pretzel]

Shop guys, are these still cracking a lot?

[1000-oaks]

Picked up a pair of used 2023 120 LV shells from fleabay and found an undisclosed punch, anyone know what temperature should be used to relax the punch back to the original position? I have a digital heat gun, and can dial it to any temperature. Thinking low and gradual.

[El Chupacabra]

Picked up a pair of used 2023 120 LV shells from fleabay and found an undisclosed punch, anyone know what temperature should be used to relax the punch back to the original position?

Confirm with a real boot fitter mag, but I'd do hot water.

[iriponsnow]

I still have 24's LV to re home.