Results 26 to 30 of 30
-
07-05-2019, 05:29 PM #26
Agree. Recent experience with replacing a sill. I measured the gap and then bought a sill--aluminum with rubber insert--that would fit the gap, based on the sill manufacturers specs. It didn't. Install sill, then measure, then cut door. Even though this isn't a conditioned spaces you want a snug fit to keep bugs out.
-
07-06-2019, 07:18 PM #27A few people feel the rain. Most people just get wet.
-
07-10-2019, 08:04 PM #28Gel-powered Tech bindings
- Join Date
- Dec 2004
- Location
- Amherst, Mass.
- Posts
- 4,686
Oooh, tough crowd to please here!
Should be pretty easy to take the door of its hinges, remove whatever you call the seal/flap/gasket that is attached to the bottom of the door, cut down the door by the thickness of the newly installed wooden tiles, then reattach the seal/flap/gasket/whatever.
Will report back once I'm finished with the gravel bed for the new shed!
(Becoming increasingly difficult to have the growing bike quiver competing with the cars in the attached garage...)Mo' skimo here: NE Rando Race Series
-
07-10-2019, 11:21 PM #29
"Should be pretty easy" sounds ominous. I've never found anything easy the first time. Trimming a door is easy if you have a saw table big enough to hold a door. Free hand with a skill saw is an art.
How much relief is needed? Take some pictures. Or paint it and call it good till the wife complains too much.A few people feel the rain. Most people just get wet.
-
07-11-2019, 07:49 AM #30Gel-powered Tech bindings
- Join Date
- Dec 2004
- Location
- Amherst, Mass.
- Posts
- 4,686
Mo' skimo here: NE Rando Race Series
Bookmarks