Results 26 to 29 of 29
Thread: Base bevel thoughts?
-
04-13-2019, 07:10 AM #26Registered User
- Join Date
- Oct 2009
- Location
- The North Country
- Posts
- 3,674
I run .5 and 3. Have done .5 and 4. Always the proprietary crosshatrch structure from Mike Desantis. No problem with these setups in any sort of snow. Even Sierra Cement.
But, my bases are always flat with burr free edges.
Any base bevel larger than 1 harkens back to old fashioned WC DH tuning. You can run 2 degrees or greater, but the skis will only turn at higher speeds.
I once had some new (after market old stock from Ebay) Head 102 Monsters that only turned at warp speed. Mike told me they had a 4 degree base bevel. Yep. The factory fucked up. (Maybe they were blems.) We set them up .5 and 3. They worked fine after that.
A friend just had her 163 SG slalom board tuned at the local REI. It came back edge high with the base structure not across the entire base. Incompetent tuning guy. A lot of places have that high end Wintersteiger, but the folks running them are complete idiots.
You already know this. Bases flat. Edges burr free.
Sent from my moto e5 plus using TGR Forums mobile app
-
04-13-2019, 01:50 PM #27Registered User
- Join Date
- Dec 2010
- Posts
- 1,332
-
04-13-2019, 07:06 PM #28
-
04-13-2019, 07:08 PM #29
Bookmarks