Results 1 to 5 of 5
-
12-28-2018, 09:47 AM #1
Drilling out Dynafit binding holes
I can't find it now, but I think I recall seeing some discussion here about drilling out the screw holes on Dynafit bindings before mounting. I'm about to mount some Beast 14s, and am considering drilling out the interference fit on the screw holes so that the binding mounts more smoothly.
Any drawbacks? What's the point of Dynafit designing the bindings to capture the screws that tightly? - are they trying to make the little threaded part of the binding help hold onto the screw?
The last Beasts I mounted (16s) were a major PITA, and I didn't drill out the screw holes on those bindings before mounting. The torx screws that Dynafit is using currently are irritating.
-
12-28-2018, 09:58 AM #2Registered User
- Join Date
- Mar 2008
- Location
- northern BC
- Posts
- 30,810
No drawbacks
All the holding power will be closer to the top of the hole, maybe they don't want you to lose the screws ?
Pay attention to if all the screws are the same
length and don't mix them up
Don't make the holes too bigLee Lau - xxx-er is the laziest Asian canuck I know
-
12-28-2018, 10:04 PM #3
-
12-29-2018, 10:24 AM #4
-
12-29-2018, 11:46 AM #5Registered User
- Join Date
- Mar 2008
- Location
- northern BC
- Posts
- 30,810
Bookmarks