WTB: B&D Shims for Classic Dynafits

[mrkbrnblm]

Looking for toe shims for the classic Dynafit pattern (Verts, Comforts, etc.). I'm interested in the 4.x and 6.xmm sizes and need multiple pairs. Anyone holding?

[John_B]

FYI it may be cheaper to just buy a sheet of LDPE and make your own with a dremel.

[doebedoe]

You just looking to save money off of buying them via Skimo.co?

[GeezerSteve]

FYI it may be cheaper to just buy a sheet of LDPE and make your own with a dremel.

Table saw is quite a bit faster

[mrkbrnblm]

You just looking to save money off of buying them via Skimo.co?

Essentially... but depending on how inexpensive they are or are not, I may resort to making my own (probably rough them out on a table saw then clean them up with a router and a tracer bit). I just like the routed out underside of the B&D shims and am hoping to avoid having to go through that much work. Hoping someone has moved onto new clamps and has a set or a couple of sets in a parts bin somewhere.


Sent from my iPhone using TGR Forums

[dcpnz]

I'm going to be needing some of these soon too.
If you looking at making some, last year I saw a post that someone had made a set with a 3d printer and was looking at either producing them or selling the file to print yourself. I don't know sh#t about materials or 3d printing but my local library has one that anyone can use. Don't know if plan happened and can't find post now - will edit if I come across it again.

Edit - found thread, what i referred to in posts 45 and 50

https://www.tetongravity.com/forums/...d.php?t=309297