Results 1 to 7 of 7
-
01-08-2017, 02:36 PM #1
Template Experts: Guardian & Kingpin hole conflicts?
Does anyone know if there are any issues with pulling Guardians and replacing them with Kingpins, mounted on the same line?
I ski 135 degree chutes switch to the road.
-
01-08-2017, 03:00 PM #2
Jay, may have to get alittle creative to have enough room. Toes look to be the issue. I am sure the heels will be fine. If you are using the powder guide templates note they are not verified and the back two holes are off. I mounted the front rear three and then centerpunched the two rear for a perfect mount.
Attachment 196697Attachment 196698Last edited by roverdoc; 01-08-2017 at 03:21 PM.
-
01-08-2017, 03:13 PM #3
Dang it. Was afraid of that.
-
01-08-2017, 03:23 PM #4
However i did not look at distance from centerline so may be ok with just a slight move fore or aft
-
01-15-2017, 10:31 AM #5
So... the heel was not a problem, but the toe was although not by much. Had to mount the Kingpins just shy of a half centimeter forward.
-
01-15-2017, 10:44 AM #6
You'll probably run into some Wrong Forum Jong!
-
01-15-2017, 11:14 AM #7
Oops, tech talk. Oh well.
Bookmarks