Results 1 to 7 of 7
-
02-12-2014, 02:54 PM #1
Help Please!!! Sollyfit plates - switching from allen key to pozi drive head screws
I am self-admittedly a jong when it comes to hardwear. I bought sollyfit plates last season when they had allen key heads. I just bought the pozi drive head screws for the plates. I don't want to strip anything, damage anything, or lose equipment. Does anyone know which screws go with which bindings and where on the bindings they go. Or can anyone e-mail me a picture of the sheet they send out with the kit that tells you what goes where.
I will be using dynafit vertical ft12s and salomon 916s from the early to mid 2000s.
Thanks. I appreciate the help!Magic Mountain Freeride Team...bringing your grom's game to the next level.
The only ski you'll ever need...http://worthskis.com/skis/the-magic/
"Errare Humanum Est"
-
02-12-2014, 02:59 PM #2
If you are concerned about screw lengths you could measure your screw length and then use this webpage to figure out what goes where. http://www.techinfo.bindingfreedom.c...gths_LD31.html
-
02-12-2014, 03:02 PM #3
Thanks. I saw that, and thought it was only for the inserts, not for the plates.
Magic Mountain Freeride Team...bringing your grom's game to the next level.
The only ski you'll ever need...http://worthskis.com/skis/the-magic/
"Errare Humanum Est"
-
02-12-2014, 03:33 PM #4
Should be samesies
-
02-12-2014, 04:08 PM #5
-
02-13-2014, 12:55 AM #6
hope this helps - it is the instruction sheet for the sollyfit kit
-
02-13-2014, 08:55 AM #7
^^^^Awesome. That's exactly what I was looking for
Magic Mountain Freeride Team...bringing your grom's game to the next level.
The only ski you'll ever need...http://worthskis.com/skis/the-magic/
"Errare Humanum Est"
Bookmarks