Check Out Our Shop
Results 1 to 2 of 2

Thread: Freeride Mount Question (not relating to shims)

  1. #1
    Join Date
    Dec 2004
    Location
    Palo Alto
    Posts
    24

    Freeride Mount Question (not relating to shims)

    getting ready to mount some Freerides and have a question about the heel elevator piece location. There are two tabs that stick up next to the rearward most binding screw hole. My question is: should the end piece of the center rail be flush with those tabs or does there need to be a certain gap there? Seems to me they would wear better if there were a small gap, then again the tabs must serve some purpose because they are there. The paper template forces a gap but the thing is crumpled out of the box and barely useable. Any experiences/opinions?

    Thanks.

  2. #2
    Join Date
    Nov 2002
    Posts
    9,477
    Get a new template faxed to you. Use that. Don't worry about gaps and taps and such.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •