Results 1 to 4 of 4
-
11-30-2010, 12:24 PM #1
Removing Valve Housing from Snowpulse Tank?
So I'm flying home from a 3.5 month stint in Chile and I want to take precautions that my snowpulse canister doesn't get nabbed by the tsa.
When I flew down here I just put it in my checked bagged (not pressurized) and it was no worries. It only had to pass TSA in Jackson. When I go back, they will have to recheck it in Atlanta. I'm just assuming with the tighter regulations and such that they won't like it if the tank isn't open.
I searched about taking it off. People say a wrench, but how would it fit on the valve housing there's only one side unobstructed (see red arrow in pics)
I tried just torquing it by hand, but no luck. I'm leaving tomorrow night, so no rush, but i gotta get this thing off.
Thanks
-
11-30-2010, 05:21 PM #2
I don't know much about snowpulse, but my first thought is to send them an email or give them a call during reg. biz hours.
-
11-30-2010, 07:17 PM #3
pm sent with suggestion
post up if it worksAggressive in my own mind
-
12-02-2010, 10:28 AM #4
Just wanted to see if you were able to get the valve off of the cannister or not.
Aggressive in my own mind
Bookmarks