Binding Mount Paper Templates

[slowroastin]

What template works with Marker Free Ten? Search bar said Jester, double checking first.

Sent from my iPhone using TGR Forums

Sent from my iPhone using TGR Forums

[Pillard]

Im mounting a pair of Look SPX12 demo/rental. I have checked this massive thread but cant seem to find any template for them. I found something Rossi but that didn't work at all. The width between my holes are 33mm (give or take a few) both toe and heel. The distance between hole pairs are toe piece 92mm and heel 80mm. Anyone sitting on a template for this binding?

[gregorys]

I'm guessing you looked at the Demo template I put up for the Axial 2? (It sounds like it's not even close.)
I'd be glad to help you create one.
It's not that hard.

You follow some steps to get measurements, and I'll crank the template. We might need 2-3 iterations before it's good, but it's really not that hard or even time-consuming.

[roQer]

Any templates work with Marker Free Ten? Search bar didn’t help.


Sent from my iPhone using TGR Forums

Look here:
https://drive.google.com/drive/folde...yYY6Gg2a3Dd245

[waxoff]

Measured from a previous mount with said binding has 120 mm from toe piece rear holes to rec line, and 115 mm from heal piece front holes to rec line. 92 and 80 mm seems accurate. Holes closest to rec line, toe and heel plate 32 mm apart. Holes furthest from rec line 35 mm apart.

Caveat. Not confirmed 100% that this puts BC at rec line with binding set to corresponding boot size though.

[Judo Chop!]

Anyone mount kingpins with inserts? Anything special I need to know?

[Pillard]

Only mounted Kingpins once. Extremely sensitive plastic in the heel plate. Be careful so you dont thread to far when adjusting forward pressure. But if you already have them mounted and just are changing the holes into inserts I dont see any problems there

[Pillard]

Here we go again! Im mounting ATK Crest 10 (Hagan Pure 10 is the same binding branded for the american market). ATK are very generous and provide a paper template themselves. https://www.atkbindings.com/wp-conte...-crest8-10.pdf The problem is that the template is not made to mount according to boot center line and with a bsl-measurement to adapt. I find it extremely complicated to find a way to get the boot center properly and totally vertical down to the ski so therefore I prefer proper paper templates. Does anyone know of one?

[chaka]

Searched with no luck. Anyone have a template for Tyrolia SLR 7.5 AC junior binders? there is a demo plate involved. thanks!

[AndreyK]

I can make you a pdf one if you PM me your sole length and email address.

Hi!
Could you make a pdf template for Marker Duke PT and BSL 305 mm?
I couldnt write a private message, my email - vk51 a yandex dot ru
Thanks a lot.

[MikeyH525]

Instead of me(new member) filtering thru the pages, does anyone have a link for an Atomic M10/L10 demo binding template?

[Pillard]

Anyone know of a template for Marker Free 200? The binding is really not new

[imaxc]

Hi,

Does anyone here have these?

Many thanks