I don't have a jig, only going off paper templates posted here.
I took a closer looker today. The toe piece lines up fine for either template.
RE: PX 15 racing
The heel piece screws do not match up on either template. If you take the Look PX / Axial 2 heel template, and move the rear most screw centre 8.2 cm forward, it should work. I'm not sure if or how this would affect the boot centre measurements. I can't add onto the template due to it being read only on my cp, but with a bit of simple measuring and marking it's a piece of cake to add onto the printed template by hand.
Unfortunately I don't have time to mount up a test before I head to work, but I will do that when I get home in 3 weeks and confirm.
*disclaimer, if you use this measurement and fuck it, too bad for you as I have not verified it yet, and I am totally jacked up on caffiene while I was measuring it.
Bookmarks