Search:

Type: Posts; User: skuff

Search: Search took 0.11 seconds.

  1. Replies
    6,841
    Views
    1,448,802

    This clamp-center-location-finder idea is...

    This clamp-center-location-finder idea is brilliant, love the concept.
  2. Replies
    6,841
    Views
    1,448,802

    Pretty sure my epoxy is overkill, but it's not...

    Pretty sure my epoxy is overkill, but it's not much hassle and it gives me peace of mind. When you get those threads lined up, the screws just roll in like the holes are tapped.
  3. Replies
    6,841
    Views
    1,448,802

    You have it right, use the back-screw method you...

    You have it right, use the back-screw method you mentioned and hand tighten. I've had 1 screw cross thread, but not worried about it because of the epoxy and steel wool.
  4. Replies
    6,841
    Views
    1,448,802

    I've reused pivot holes and bindings on at least...

    I've reused pivot holes and bindings on at least 4 pairs of skis without the screw keeper issue you refer to. But if it's a problem, you can always take the screws out of the binding and gently drill...
  5. Replies
    6,841
    Views
    1,448,802

    I deleted that, because I posted it in the wrong...

    I deleted that, because I posted it in the wrong thread, and I didn't understand your answer. :o Until now, after you said the same thing twice. Thank you.



    Mounted a pair of 2001-2002 200cm...
  6. Replies
    6,841
    Views
    1,448,802

    Has anyone used a boot toe mark to mount...

    Has anyone used a boot toe mark to mount bindings? Do I use the actual boot toe, or the flange(?) part in front?

    I have an older ski and the boot toe is the only reference point.
  7. Replies
    6,841
    Views
    1,448,802

    I recently asked my local shop to order 2 sets of...

    I recently asked my local shop to order 2 sets of FKS screws, toes and heels. ~$12.50 per set. They arrived at the shop a few days ago but I'm going to wait to pick them up.
  8. Replies
    6,841
    Views
    1,448,802

    I thought the process was... jig at correct bsl,...

    I thought the process was... jig at correct bsl, drill the toe holes, then close the jig at the heels only by 5mm and drill the heels? NOT THIS

    caveat- I've only used the paper template to...
  9. Replies
    6,841
    Views
    1,448,802

    That makes sense, I have a copy of the Look Tech...

    That makes sense, I have a copy of the Look Tech Manual from 2004/05 that says, "Binding holes should be 5mm or more apart".
  10. Replies
    6,841
    Views
    1,448,802

    Thanks, I'll give it a shot.

    Thanks, I'll give it a shot.
  11. Replies
    6,841
    Views
    1,448,802

    Looking to mount an FKS binding on a ski...

    Looking to mount an FKS binding on a ski previously mounted with a Marker binding. Using 2 of the Marker toe holes would put my boot very close to boot center. The problem(?) is that the 2 Marker...
  12. Replies
    6,841
    Views
    1,448,802

    Read somewhere here some folks use a soldering...

    Read somewhere here some folks use a soldering iron to warm up the screw and soften the epoxy for removal.

    Since I don't have a soldering iron I've used a propane torch to heat the tip of an...
Results 1 to 12 of 12