Search:

Type: Posts; User: rfconroy

Search: Search took 0.06 seconds.

  1. Replies
    29
    Views
    5,405

    I feel like if I was the designer for these, or...

    I feel like if I was the designer for these, or spec'ing the hardware kits, I would default on T25 regardless, less likelihood of stripping, and drivers are more common than pozi drive. Also: I am...
  2. Replies
    29
    Views
    5,405

    Im in the same boat. I found that the phillips...

    Im in the same boat. I found that the phillips drive fasteners found on most binders tend to strip over time, since they're made of SS. So I swapped them out for Torx drive which has improved ease of...
  3. Replies
    29
    Views
    5,405

    The bit for QK inserts is 9mm, BF is 9.5. So if...

    The bit for QK inserts is 9mm, BF is 9.5. So if you put the BF inserts into a QK hole after its tapped, all the inserts will stick proud by about 0.5mm. Putting all the clamping force onto the...
  4. Replies
    29
    Views
    5,405

    Pro Ski in North Bend does it too, but I have...

    Pro Ski in North Bend does it too, but I have seen some issues with their mounting... Using the QK bit for a BF insert....

    REI actually does QK mounting as well.

    If you're local and want to...
Results 1 to 4 of 4