Search:

Type: Posts; User: Spyderjon

Page 1 of 6 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    2,876
    Views
    373,365

    Yep. I installed inserts in to quite a few Kore's...

    Yep. I installed inserts in to quite a few Kore's without issue.
  2. mdf9e4, Scott are offering a 40 litre pack for...

    mdf9e4, Scott are offering a 40 litre pack for 19/20 and it's available either as a full system (pack + the E1 gubbins) or as a pack only in to which you can install the E1 system from you BD pack....
  3. Never heard of shortening at the tip end. I've...

    Never heard of shortening at the tip end. I've shortened plenty at the grip end using your method. On composite/carbon poles you should wrap the pole in masking tape and cut it with a fine hacksaw...
  4. Replies
    7
    Views
    442

    This is an easy remount. The rear toe hole...

    This is an easy remount. The rear toe hole locations clash but both bindings have those holes at 40mm centres so you just mount the Attacks back a few mm and you can then share the rear STH2 holes....
  5. You don't know what you don't know :biggrin:

    You don't know what you don't know :biggrin:
  6. There's never any pizza left over in my shop.

    There's never any pizza left over in my shop.
  7. I've hot boxed hundreds of pairs of skis with the...

    I've hot boxed hundreds of pairs of skis with the bindings on for four hours at 150F/65C with absolutely no ill affect on the binding grease, or anything else.
  8. Replies
    37
    Views
    3,177

    The new Hoji Free Tours have a full AT sole so...

    The new Hoji Free Tours have a full AT sole so there's not a hope in hell of them fitting in a alpine/GW AFD - well not without a lot of sole grinding. Your best bet would be the WTR AFD but you'll...
  9. Replies
    14
    Views
    565

    282024 282025

    282024
    282025
  10. Replies
    34
    Views
    3,346

    Whitedot Ragnarok ASYM

    Whitedot Ragnarok ASYM
  11. Replies
    2
    Views
    265

    The pivot shafts/pins are not available...

    The pivot shafts/pins are not available seperately but if you go to any Salomon/Atomic dealer and order part no. L376503001 then in about a week they'll receive a bag containing 2no. toe base plates,...
  12. Replies
    16
    Views
    860

    LOL

    LOL
  13. Replies
    8
    Views
    523

    That part is not available as a spare. Look (like...

    That part is not available as a spare. Look (like all of the other binding makers) don't list part numbers for every component and don't offer every part as a spare. Here's the 19-20 Parts List. The...
  14. Replies
    8
    Views
    523

    Pivot/FKS 18 GripWalk AFD

    Just placed my 19/20 spare parts order with Look for delivery in Sept/Oct and thought that the P18 loving mags might be interested to know that a replacement GripWalk AFD will be available from then....
  15. Replies
    5
    Views
    290

    Any Atomic or Salomon retailer can order in the...

    Any Atomic or Salomon retailer can order in the part from Amer. Assuming it's available you'd get it in about a week.
  16. Replies
    2,097
    Views
    243,524

    The vast majority of my toe shimming work is...

    The vast majority of my toe shimming work is based upon a shim thickness determined from a Neutralizer Balancer which uses a flat horizontal surface as its initial reference hence the need to measure...
  17. Replies
    2,097
    Views
    243,524

    Your logic is only correct for MNC toes that have...

    Your logic is only correct for MNC toes that have a adjustable height toe wings with the boot sitting on a fixed height AFD, like the Warden. On a Shift it's the other way around. And if the WTR toe...
  18. Replies
    2,097
    Views
    243,524

    Yep, I use a jig to plot the hole locations and...

    Yep, I use a jig to plot the hole locations and drill them on a vertical mill with a stubby bit to avoid the usual 'wander' that you often get when drilling acrylic.

    The Shift has fixed height...
  19. Replies
    2,097
    Views
    243,524

    Read the posts above on that exact subject.

    Read the posts above on that exact subject.
  20. Had my Look rep in my shop yesterday asking why...

    Had my Look rep in my shop yesterday asking why I've ordered so few bindings for 19/20. My answer was the same as last year: "no MNC offering" I sell loads of Wardens and Attack AT's, in both the...
  21. Replies
    2,097
    Views
    243,524

    A bit of toe shimming action: ...

    A bit of toe shimming action:

    http://snowmediazone.com/the_zone/data/500/medium/Shift_6mm_toe_shims.jpg
  22. Replies
    27
    Views
    1,273

    +1. I've use them in my Mercurys/Vulcans for...

    +1. I've use them in my Mercurys/Vulcans for years. Yes, technically they're not the same as sole canting but they work for me.


    Total bollux. I've done hundreds of shim set-ups for people,...
  23. Replies
    2,097
    Views
    243,524

    Not a real problem using the 120mm crampon, not...

    Not a real problem using the 120mm crampon, not the best solution but ok. I was pretty scathing of Salomon when they announced that they were only offering 100mm and 120mm crampons and not a 110mm....
  24. Replies
    2,097
    Views
    243,524

    Vulcans/Mercurys have a number of very hard...

    Vulcans/Mercurys have a number of very hard rubber pads within their soles to specifically counted this issue.
  25. Replies
    20
    Views
    792

    Nice work.

    Nice work.
  26. :D

    :D
  27. Replies
    7
    Views
    549

    That's not a Radical 2.0, the underside of which...

    That's not a Radical 2.0, the underside of which looks like this:
    http://snowmediazone.com/the_zone/data/500/medium/Rad_2_heel_underside_.jpg

    What you have was originally sold as the Radical...
  28. Replies
    2,097
    Views
    243,524

    19/20 list price in the UK is the same as this...

    19/20 list price in the UK is the same as this season at GBP400 (ie GBP333.33 + 20% UK/EU tax)
  29. Replies
    2,097
    Views
    243,524

    Rubber hinge spacer now sorted (used an...

    Rubber hinge spacer now sorted (used an off-the-shelf cable grommet but cold temperature performance is an unknown) and the lock nuts swapped out for a proper washer/nylock nut. Assembly is rock...
  30. Thread: B.A.M.

    by Spyderjon
    Replies
    6
    Views
    473

    This is the Shift Red people have been asking...

    This is the Shift Red people have been asking for. Time will tell whether there's sufficient numbers of that customer profile (who'll accept the weight penalty over a Shift) to make it viable.
  31. Replies
    17
    Views
    447

    Scott Scrapper 95 or the 95W

    Scott Scrapper 95 or the 95W
  32. Replies
    2,097
    Views
    243,524

    GoldenBC, impressive wound. Whilst you're laid up...

    GoldenBC, impressive wound. Whilst you're laid up I'd get working on incorporating a 30' drop to a flat landing in to your story! Best wishes for a speedy recovery. .
  33. Replies
    0
    Views
    155

    FS: Dynafit Rad 2 ST's & FT's to clear!

    I'm having a clear-out of some stock which I can ship to the US tax free so with the current weak GBP to US$ should make the prices attractive:

    4no. pairs of Radical 2 ST 120mm @ GBP245.00 each...
  34. Replies
    2,097
    Views
    243,524

    Had a chance this afternoon to do a bit of...

    Had a chance this afternoon to do a bit of measuring of my protptype climbing bar angles measured off a Shift that was mounted for my Dynafit Mercury 304mm bsl boot (which actually measures 306mm in...
  35. Replies
    2,097
    Views
    243,524

    I knocked this up from an off cut of alu bar I...

    I knocked this up from an off cut of alu bar I had in my scrap bin so was limited by the size if the stock but it'd be easy to include a prutruding 'wing' on each side for easy activation with a pole...
  36. Replies
    2,097
    Views
    243,524

    XXX-er, Yep, I've used the slot in the existing...

    XXX-er, Yep, I've used the slot in the existing climbing bar.

    Just slimmed it down a bit so it comes in at sub 40g.
    ...
  37. Replies
    2,097
    Views
    243,524

    My prototype Shift high climbing bar: ...

    My prototype Shift high climbing bar:

    http://snowmediazone.com/the_zone/data/500/medium/High_Climbing_Bar_-_flat.jpg...
  38. Replies
    6
    Views
    188

    Yep I'm selling, I think I've got over 20 sets...

    Yep I'm selling, I think I've got over 20 sets available. But standard airmail isn't quick, usually 10-14 days but I can't give a guaranteed date. The parcel will be delivered by USPS at your end. If...
  39. Replies
    6
    Views
    188

    Dynafit crampons work fine with Kingpins that are...

    Dynafit crampons work fine with Kingpins that are mounted for a 315mm sole length and longer otherwise the leading edge will crash with the tour/ski lever.

    Dynafit have distributed directly to UK...
  40. Replies
    2,097
    Views
    243,524

    Yes, no, maybe. Probably depends upon the...

    Yes, no, maybe. Probably depends upon the make/model of boot (ie solid or hollow lugs etc) and your skill level. A metal insert would have to be fitted to avoid rapid erosion etc. In the grand scheme...
  41. Replies
    12
    Views
    583

    This ^. The Ripsticks do not have different...

    This ^. The Ripsticks do not have different sidecuts on each side of the ski, the difference is only in the rocker/camber.

    From Elans website:
    "The Amphibio profile is a revolutionary ski design...
  42. Replies
    2,097
    Views
    243,524

    More speed :D

    More speed :D
  43. Replies
    2,097
    Views
    243,524

    All the brands use super hard anodised aluminium...

    All the brands use super hard anodised aluminium so not only very difficult to bend they'll likely to crack pretty quickly if you try. Most of them have enough meat on them to grind a bit off the...
  44. Replies
    2,097
    Views
    243,524

    The 100mm crampon is 106mm internal face to face...

    The 100mm crampon is 106mm internal face to face and the 120mm is 126mm internal face to face. Bend (if you can) at your own risk.
  45. Replies
    2,097
    Views
    243,524

    Use the 'Search Thread' function at the top of...

    Use the 'Search Thread' function at the top of this page - the template's in here somewhere.
  46. Here's what Scott concerning say concerning their...

    Here's what Scott concerning say concerning their E1 Patrol AP30 pack:
    - It takes 20-40mins to charge the system via the USB lead, depending upon the power source
    - It takes 40 mins for the pair of...
  47. Replies
    129
    Views
    9,117

    If there's no serial number then that's a...

    If there's no serial number then that's a mismatched set. The number will only be on the back of one of the heel dildo's and is pretty feint so hard to spot.
  48. I think that'd really help avoid confusion.

    I think that'd really help avoid confusion.
  49. According to Salomon that's not how you're...

    According to Salomon that's not how you're supposed to adjust it. The instructions included with the bindings state that the raised silver rectangle is supposed to be centred between the arrows. Not...
  50. Replies
    2,097
    Views
    243,524

    GBP59.00 (inc 20% UK VAT) from me, when I had 'em.

    GBP59.00 (inc 20% UK VAT) from me, when I had 'em.
Results 1 to 50 of 300
Page 1 of 6 1 2 3 4