Search:

Type: Posts; User: jgb@etree

Page 1 of 6 1 2 3 4

Search: Search took 0.19 seconds.

  1. Thread: GUNS!!!!!!!!

    by jgb@etree
    Replies
    8,699
    Views
    637,502

    I've found it can happen when you mix a forged...

    I've found it can happen when you mix a forged lower with a billet upper or vice versa, but it often means that the upper is out of spec. Out of spec or worn takedown/pivot pins can cause it too.
    ...
  2. Replies
    1,803
    Views
    122,170

    My wife drives a '15 s63 and it's been a damn...

    My wife drives a '15 s63 and it's been a damn good car, but they definitely aren't cheap to fix. Took it in 3 weeks ago to have the airbag recall done. They found a leak at the oil filter housing...
  3. Thread: GUNS!!!!!!!!

    by jgb@etree
    Replies
    8,699
    Views
    637,502

    Is that the little rubber thingey that wedges...

    Is that the little rubber thingey that wedges behind the takedown pin? I tried using one in the past - wasn't thrilled with it. Ended up replacing the lower with a Mega which has a small set screw...
  4. My son is only 10, so I have yet to research &...

    My son is only 10, so I have yet to research & implement smartphone controls and can just focus on controlling and filtering wifi access in the house. I have a series of wifi access points that...
  5. Replies
    105
    Views
    18,337

    I like the duluth trading company firehose...

    I like the duluth trading company firehose foreman pants. They seem to wear well, are comforable & stretchy and water beads and rolls right off of them.
  6. Replies
    173
    Views
    13,883

    Corbett's customer service is kick ass. Bought a...

    Corbett's customer service is kick ass. Bought a pair of boots for my son there a few weeks ago on a Tuesday night, knowing that they only ship US orders on Tues and Friday. Planned on them...
  7. Replies
    2,287
    Views
    148,396

    The master at falling from chairlifts has spoken.

    The master at falling from chairlifts has spoken.
  8. Replies
    21
    Views
    1,274

    When you're ready for hard mode, try a corded...

    When you're ready for hard mode, try a corded jigsaw. Big difference in power!

    To the OP's question, I have a standard foam roller and a hollow trigger point therapy roller. I use the foam for...
  9. Replies
    11
    Views
    445

    He was in a pair of those Roces that adjusted...

    He was in a pair of those Roces that adjusted from ~15.0-18.0 before the Full Tilts. They worked very well and would likely fit the bill again, but he definitely noticed a big difference in comfort...
  10. Replies
    11
    Views
    445

    Definitely. I think you're right on the $$$. ...

    Definitely. I think you're right on the $$$. Thanks again.
  11. Replies
    21
    Views
    1,274

    Bought one of those adapter kits last year. I...

    Bought one of those adapter kits last year. I dont like the foam ball shown in your pic. The solid rubber cone & ball are the tits though. Only downside is that it has shredded the sides of my...
  12. Replies
    21
    Views
    900

    Check out the Baofeng UV5R on Amazon. They're...

    Check out the Baofeng UV5R on Amazon. They're ~$25 and work great. Highly recommend buying a programming cable for $10-15 and using the Chirp software to program frequencies into the radio. We...
  13. Replies
    11
    Views
    445

    Appreciate any input he might be able to provide....

    Appreciate any input he might be able to provide. I'll definitely PM you later to take you up on the sticker offer - he'd be sooo stoked, especially coming by way of a spancered athlete. Very kind...
  14. Replies
    11
    Views
    445

    Full Tilt Fit Questions

    Hoping that someone will know enough about these to be able to help me out as I've never worn a raichle or FT. My 10yo son has been wearing the FT Growth Spurt (small) boots for 2-3 seasons. They...
  15. Replies
    63
    Views
    2,491

    Ca5wXojemRM

    Ca5wXojemRM
  16. Shirts showed up today. XXL fits me (6'3" 215#)...

    Shirts showed up today. XXL fits me (6'3" 215#) fine.

    Thanks a bunch for doing this MiCol!
  17. 9" on the deck and more on the way? Yes please....

    9" on the deck and more on the way? Yes please.

    Someone needs to step up & start a 19/20 thread!
  18. DW was tapped as a last minute replacement for...

    DW was tapped as a last minute replacement for MNIAW who was reportedly found stumbling around drunk on burgundy wine shouting 'get in ze choppa' minutes before the work was to begin.

    Solid work,...
  19. Towers for the black quad flying today. :yourock:

    Towers for the black quad flying today. :yourock:
  20. Replies
    77
    Views
    2,760

    Similar drama around the range at my gun club in...

    Similar drama around the range at my gun club in suburban CT. Range was established in 1924 in the middle of farmland. Suburban sprawl encroached over the years, but the neighbors knew what they...
  21. Thread: Wagon Stoke

    by jgb@etree
    Replies
    2,708
    Views
    185,617

    Not sure if you are familiar with them, but a FL...

    Not sure if you are familiar with them, but a FL company called Arnott Industries does replacement air suspension parts (airbags, compressors, valve blocks, etc) for Audi, MB and other manufacturers...
  22. He posted in the PR today: ...

    He posted in the PR today:

    https://www.tetongravity.com/forums/showthread.php/330337-Pitt-Bull-Attack-WWMD?p=5787307#post5787307
  23. Looks like a good time was had by all. ...

    Looks like a good time was had by all. Definitely bummed that I couldn't be there for the shenanigans....and to represent the under-50 crowd :fm:
  24. Replies
    121
    Views
    4,619

    You have a customer named Ian with an a4 cabrio?...

    You have a customer named Ian with an a4 cabrio?

    Overcharge him and confiscate his man card. You can regrip your putter with the proceeds.
  25. Replies
    2,503
    Views
    341,843

    Love that RC51 next to you. All you need to...

    Love that RC51 next to you. All you need to complete the Honda trifecta is an Erion 929.
  26. Paid. Thanks.

    Paid. Thanks.
  27. Replies
    30
    Views
    1,532

    Credit card fraud. Someone got your details,...

    Credit card fraud. Someone got your details, order the phones and planned to grab them from your porch before you did so they could resell the phones.
  28. Is this the party I read about on craigslist?!?...

    Is this the party I read about on craigslist?!? :fm:

    Bummed to miss out. It used to be easy to make these pre-kid - now, not so much.

    Hope you all have a blast and make a proper offering to...
  29. Dubnik 1 M Gray waxloaf 1 S Red doebedoe 2 M...

    Dubnik 1 M Gray
    waxloaf 1 S Red
    doebedoe 2 M Gray/Crimson
    N1CK 2 Large Gray/Crimson
    SorryBro 1 L Purple
    metaltrilogy 1 M Purple 1 M Crimson
    2FUNKY 1 L Crimson
    alias_rice 1 L Crimson
    caulfield...
  30. That'll probably work. Give me a heads up if you...

    That'll probably work. Give me a heads up if you end up deciding to do a run of them. Thanks.
  31. You going to have any bross hoodies in stock...

    You going to have any bross hoodies in stock again soon?

    Stoked on this baselayer - thanks!
  32. Dubnik 1 M Gray waxloaf 1 S Red doebedoe 2 M...

    Dubnik 1 M Gray
    waxloaf 1 S Red
    doebedoe 2 M Gray/Crimson
    N1CK 2 Large Gray/Crimson
    SorryBro 1 M Purple
    metaltrilogy 1 M Purple 1 M Crimson
    2FUNKY 1 L Crimson
    alias_rice 1 L Crimson
    caulfield...
  33. My wife already threatened to throw me out of the...

    My wife already threatened to throw me out of the house if I part it out - she doesn't want a half disassembled car hanging around and me dragging parts in and out of the house and asking her to ship...
  34. Yeah, the allroad - I still have it. Tomorrow...

    Yeah, the allroad - I still have it. Tomorrow will be 15 years to the day from when I bought it. Finally rolled 95,000 a few weeks ago, and CEL-itis has set in. A flex joint just let go too, but I...
  35. Ugly. What are your thoughts on deleting EGT's...

    Ugly.

    What are your thoughts on deleting EGT's on a street driven 2.7t? Passenger side shit the bed which put the engine into limp mode and severely limits boost. The $550 for a pair doesn't...
  36. Thread: GUNS!!!!!!!!

    by jgb@etree
    Replies
    8,699
    Views
    637,502

    Loving all of the old Winchesters getting posted...

    Loving all of the old Winchesters getting posted up. When my Dad came over from Italy, his family settled in New Haven. Many of his neighbors and eventually his friends worked in the Winchester...
  37. Replies
    5,863
    Views
    344,139

    Shouldn't you be calling yourself DaveNJ?

    Shouldn't you be calling yourself DaveNJ?
  38. Replies
    45
    Views
    1,522

    Of course it is, but my workshop is in an old...

    Of course it is, but my workshop is in an old detached carriage barn that is not.
  39. Replies
    45
    Views
    1,522

    I've tried a bunch, but nothing seems to work as...

    I've tried a bunch, but nothing seems to work as good as a kerosene heater

    https://cdn11.bigcommerce.com/s-3frfhvmm7i/images/stencil/1280x1280/products/117/403/KW-24-web__98270.1497642147.jpg
  40. Something wrong with using the tire as a step? ...

    Something wrong with using the tire as a step? If so, I guess you can get one of these:

    https://www.amazon.com/Doorstep-Rooftop-Doorstep-Vehicle-Hooked/dp/B07NKZG75W

    Open a door and hook it...
  41. Replies
    151
    Views
    5,943

    Reminds me of the powder blue 71/72 Eldorado I...

    Reminds me of the powder blue 71/72 Eldorado I drove as a teenager. 8.2L v8, iirc. Fucking cat was hudge
  42. Replies
    123
    Views
    4,858

    Yep. My mistake. I have a shitload of mags for...

    Yep. My mistake. I have a shitload of mags for those. I found a pawn shop in Alabama that was sitting on a pile of new old stock ~10 years ago and bought 20 for $20/ea. Last I checked they were...
  43. Replies
    123
    Views
    4,858

    2nd gen s&w 10mm's will probably handle 50,000psi...

    2nd gen s&w 10mm's will probably handle 50,000psi or so without detonating in your hand... they're made out of chunks of solid steel. If the pressure were any higher, I'm thinking maybe a howitzer? ...
  44. Replies
    123
    Views
    4,858

    Maybe a .50GI Glock conversion? Unless someone...

    Maybe a .50GI Glock conversion? Unless someone makes a 2011 with a double stack - I can't imagine stuffing 13 of those fuckers into a 1911 without a comically long mag.
  45. Replies
    123
    Views
    4,858

    I feel the same way about chairlifts (and really...

    I feel the same way about chairlifts (and really any structure over 15' in height, but that is too broad of a category to focus my advocacy on). Too easy for a suicidal individual to just jump off...
  46. Replies
    33
    Views
    1,366

    Calling BS on this. It's a well known fact that...

    Calling BS on this. It's a well known fact that the reason the Mexican Summer Olympic team is so weak is due to everyone who can run, jump or swim already being in the US.
  47. Yeah, make sure you have time to actually use the...

    Yeah, make sure you have time to actually use the boat before buying it. I bought a new 24' cc (robalo r242) 3 years ago. Spent a bunch of extra dough getting it outfitted to my exact...
  48. Replies
    212
    Views
    15,817

    I'll take a jar or two

    I'll take a jar or two
  49. Replies
    340
    Views
    21,506

    Another victim of TDS?

    Another victim of TDS?
  50. I've got a 2007 Grand Cherokee getting ready to...

    I've got a 2007 Grand Cherokee getting ready to roll 200k (198xxx currently) and it still has an active bumper to bumper manufacturers warranty (lifetime, unlimited mileage) :fm:
Results 1 to 50 of 300
Page 1 of 6 1 2 3 4