Good questions!
First, it starts with just being an insert nerd and the cost just being time and $15/ski pair for inserts.

The trofeos are primarily for a pending pair of new lighter spring...

I'll start by admitting my soon certain death... But with a pair of Trofeo+'s in hand and a pile of BF inserts, I'm going to pull the trigger on adding Trofe heel inserts to two pairs of skis that I...

the button brakes are quite bad. I need to sit down and work on mine. a little bit of snow gums them up and they don't really release

Most excellent, thx much

So I'm gonna be putting inserts in for a set of ATK Trofeo Plus's (Trofeos + the R01 heel baseplate).
Does anyone know the right Binding Freedom screws for these?
The BF website doesn't have them...

^^^ got it, will dig some more in the parts drawer

^^^ Thx, kinda remember that. But no idea where I put it

It’s the freeraider 14, but it’s prob just like the r12 - it’s raised a bit in the front to accept the al09 spacer hooks underneath. The raised bit isn’t on the actual mount interface… so I guessing...

Apologies, as I'm sure this has been asked, but coudnt find anything with a bit of scrolling... On FR14s, ok to run without the al09 spacer, leaving that slight gap in front of the front screws? Or...

I wish the buttons were asymmetric - much easier to hit the inside one, versus outside right one.
Good post. I’ve been thinking on a better way than getting super low, in order to save my right...

This is a pretty obvious question, but just wanted to confirm before dropping $$$ on new binders...
I'm working on fitting some likely new ATKs (likely Kuluar) onto some skis with existing hole set...

Yes, dorkery for sure! I’ll check out the HR10 too. First question is whether to add the couloir ski… then bindings… then inserts vs direct isn’t… then do I add heel inserts to the existing bc skis....

Sorry if this has been covered… dang tgr search. My main bc skis are mounted with inserts for freeraiders, which with brakes and spacer are 370 ish grams. I’m on the fence on adding a couloir ski -...

Excellent

^^^ on the new Evo...
spyderjon - The square toe mount pattern, or trapezoid? Either way, good that not a new-new mount pattern!
I actually like the brake button, and that you don't need to spin...

^^^Thank you both, I think cat's dimensions are correct. And unfortunately they're prob not gonna work around the holes of my existing dynas. So I'll look at this again in a year or two, and will...

Great info in this thread. I've read most but still not 100% clear on the mounting pattern for say the current R12 and FR14. Can someone tell me which is current from below? I'm guessing the last...

Thx all, so they are different. Hmmm... more to try to figure out

So are the new BD Helio 350's the same as the new ATK Raider 12, except with a different toe piece without the hard/med/soft pin adjustment? I've read most of this + the Blister review and that seems...