Search:

Type: Posts; User: auvgeek

Search: Search took 0.16 seconds.

  1. Replies
    1,389
    Views
    636,201

    Sticky: Just wanted to bump this thread. Maybe it's just...

    Just wanted to bump this thread. Maybe it's just me, but after a forward-pressure related prerelease issue, I've taken to running my fwd pressure a little higher. My boots (Full Tilts) seem to be a...
  2. Replies
    1,389
    Views
    636,201

    Sticky: Same here. I'd use Jon's again in a heartbeat.

    Same here. I'd use Jon's again in a heartbeat.
  3. Replies
    1,389
    Views
    636,201

    Sticky: I'm no shop tech, but IIRC it's typical to line...

    I'm no shop tech, but IIRC it's typical to line up the FKS jig and drill the front holes and then move the rear 5mm forward to allow the forward pressure to be in the middle of the range. I read...
  4. Replies
    1,389
    Views
    636,201

    Sticky: ^^ Try comparing to Jon's Rossi FKS template. ...

    ^^ Try comparing to Jon's Rossi FKS template. Eyeballing it, it looks very close.
  5. Replies
    1,389
    Views
    636,201

    Sticky: ^^ Do you not have access to a printer or are you...

    ^^ Do you not have access to a printer or are you a retard?

    If the former, that sucks. If the latter, read the first post in this thread. I award you no points and may god have mercy on your...
  6. Replies
    1,389
    Views
    636,201

    Sticky: With my print scaling, the Plum R1 and Dynafit R2...

    With my print scaling, the Plum R1 and Dynafit R2 templates have exactly the same toe. I also verified this with my actual toepiece, and it works perfectly.
Results 1 to 6 of 6