bar width/sweep, brake angle, grips, all seem to be covered
i have wrist issues from old injuries and use a bar with slightly more backsweep than most and also run them a hair chicago style since im...

couldnt attach pic in pm so adding here

this is what i got
369211

which fit these type binders
https://www.tetongravity.com/forums/attachment.php?attachmentid=196673&d=1483856756&thumb=1

i...

my limited understanding is that the purpley cheap leds are ok for veg, but really lack the correct light spectrum and power for flower, and the wattage claims are overhyped to say the least
ive...

heres my current girl, wanted to experiment this round so kept it to 1 plant, learned a lot this run and really dialed in a few things ive previously struggled controlling

i picked up a cheapo...

yeah those pre mixes do tend to run hot, and can be inconsistent batch to batch as well, i would stick to just water until the plants start to tell you they want more nutes

i will say that imo...

vapcap if you are ok with carrying a small torch, nothing else comes close for simplicity

what grow medium?

assuming some sort of a cocoa coir type mix its pretty much impossible to over water in smart pots
you should treat them as if its a hydro drain to waste setup rather than as if...

i think i have some for the older rossi fks with the geze style toe in a box in garage, no clue if compatible but if so let me know and will dig them out

its not d8 flower though...
its cbd flower, which like 99% of cbd flower actually has illegal levels of d9 in it to call it hemp, which is another issue altogether...
then they spray d8 distillate...

imo d8 is sketch...
its legality is... debatable...
the chemistry to convert cbd to d8 is not well refined, the resulting isolate is not well understood, and the testing for d8 is very much not...

thanks good info
think i followed on zwift, mostly dig barely ride is me

so if i choose route, then choose workout, then hit ride, will it give me route badges while i do workouts?
is there any...

officially joined the smart crew last week
been on a dumb trainer for ~3 years doing mellow spins nightly for injury rehab and beer justification
think im ready to ramp it up a notch just need to...

interested... i was just emailing a guy on cl north of pdx about his as new pair listed for 150 but he lives hr and a half from me and ive been lazy... i dont mind holes and run old pivots (geze toe)...

PSA
Manitou Circus Expert, 1 1/8 Straight Steerer, 20mm axle, 26in wheel, on sale at Wiggle $238
this didnt seem worthy of its own thread so figured throw in here in case anyone knows of someone...

i havent experimented with tinctures too much, best method depends on quality of input, type of carrier, and desired potency and medicinal value

i would look over the recipe "bad kat" uses as a...

i also run trim and random old jars to clear out space, usually have a few oz of various bubble sitting around

havent seen edibles mentioned, great for hash use, the potency and terp increase lets...

top of my head answer...
b screw limit needs to be increased

when dumping multiple gears there is enough gap between der and cassette to not bind
when shifting a single gear the b screw is...

message received

im hoping these have the dynastar dna i know and love with a little more playfulness for slow speed casual skiing and friendlier to my knees

sounds like similar build to me, but ive got the large tamok, good for resort use, definitely on the freeride fit side but i didnt find exchanging worth the hassle, love the jacket its great quality...

ive got some first gen protos i snagged on covid clearance sitting here with fks to slap on, thinking about mount points after seeing some comments and reviews

any more feedback from those with...

7 speed, used to have it friction f/r but with it on the trainer i swapped front to index, rides like a dream except the frame is sketchy as fuck with the 30 year old glued together cf tubes

oh my sex, the kevlar weave seatpost takes me back hahaha

i never attained bling status in mtb during that era, loved my m2 stumpy with judy and speed springs but it was nothing special with all...

amp research... so drool worthy in its time, anything to get away from elastomers

and then hope and was it ringle? did 4 bolt hubs which was also a pita



bicyclists have been doing dumb shit...

fyi weight weenies have been running 3 rotor bolts for weight savings for years, dh/enduro/xc whatever, it works fine and ive never heard anyone have any issues with it
i would tell her its for...

you got more info on this?
i got a spring pass last year and havent heard shit from them since they closed up the day after i bought the damn thing

spec p3 only comes in one size, 420ish reach and i think 15ish bb drop, they used to be considered on the large side but would be pretty middle of the road now
my 6'4'' friend has a 2019 with 80mm...

budget?

cl, pb, and fb "dirt jumper classified" group will have the most active listings for sale i know of

as far as sizing, im your same height and imo when talking dj bikes reach has less...

my evening cardio bike training mantra is "calories in, calories out"
if you are the type of person that needs motivation to stay on your workout routine, i encourage you to try this technique
i...

sounds likely its just the rim thats offset and no need to adjust spokes, but if it is needed a full spoke turn (alternating spoke directions) will move the rim roughly 4mm, ive done this dozens of...

the extraction of capital to the cycling industry from the efforts of volunteer advocates leading to an unsustainable tipping point for providing recreation opportunities to the public where...

stumbled across these other day, basically what i would build from scratch but already done for you: dt swiss xm 1501 spline one 25mm 29er boost - $750...

no filter, tuesday 6pm, s. salem area looking towards jefferson which you can usually see poking up right in the middle there...

339623


today smoke has settled lower and air quality is way...

finished, haha good one :tongue:

nice rockwork in here lately, im jealous you all have something to work with when the dirt is shit, im just on dust control duty at local jumps till rain comes back

not familiar with the breg brace specifically, but it looks similar to a bunch of braces ive had over the years

do the straps that wrap around and under your foot have any elasticity and stretch?...

fyi 20mm forks have always been the oddball and had 110 spacing, boost just moves the disc flanges a bit

ive never seen a universal axle to use with 20mm fork and qr wheel, i dont even know how...

used 500-1000, new 1200-1500

reg/med/short would be your size, whatever the brand calls their smaller model

low end dj forks really suck, you want a circus expert or better if your bank account...

its been awhile since ive worked on a motion control fork so forgive me if im off base here...
did you open/service the damper?
how much and what type of splash oil did you use in lowers?
are the...

when your socks match the sunset :cool:

well played

all my mtbs are 26... the correct wheel size :rolleyes:

ive got a holy roller in the pile of tires in the garage, its not a bad tire by any means, but it weighs substantially more and has somewhat...

no pics, it wasnt that type of dig day, just some watering and basic maintenance on the local djs to keep things running along

but today was important

ive mentioned how fun it is to design...

pretty sure teledad is right...
(old erd - new erd) / 2 = x
old spoke - x = new spoke

dts spoke calc can do straight pull user defined, so if you have calipers can pop numbers in, theres one...

oh wow i had no idea this was an actual thing!
ive been using this folded up lift ticket as that tool for the past 9 years haha
335711

interested in dalbellos, question on fit, will send pm

i added spaces, im not paid enough for full sentences...
:the_finge

i know this is a mostly dentist crowd... but anyone have time on the schwalbe billy bonkers?

i love the tabletop, but its discontinued, fantastic front tire for dj/pumptrack

i just got a 2.35...

shock stroke is not directly proportional to suspension travel, it depends on pivot/link placement, for most bikes its not a huge difference, but for some it can be worth noting

think about a high...

picked up a beat wheelset on cl featuring a hadley ss rear hub and blown out rims
fresh bearings all around, dt comps, rim of choice, and a day twisting the spoke key got me some fancy new dj wheels...

manipulating human behavior is what i enjoy most about trailbuilding... idk what that says about me though haha

here is my most recent manipulation attempt
this is the end of a small jump line,...

ive been missing this thread greatly... damn grad school has kept me away from my shovel far too frequently these days
had a conference call today with city park director and bike park consulting...

doh, mine got cancelled, lamesauce, thanks for the heads up op, hope you all get yours and enjoy!