Tab Content
No Recent Activity

3 Visitor Messages

  1. Oh, be sure the template is printed to scale.
    Print it and then measure the listed dimension with a ruler. If they don't match, the PDF has been scaled.
    (I've even started to mount something where the scale was off, so it's a very easy mistake to make. Hadn't drilled any holes yet, fortunately. But still.)
  2. My template is for DEMO bindings. Hopefully you're trying to mount a demo binding with my template, not a regular one. (You do note demo, but I've had people trying to mount regular ones and complaining about my template. So just checking.)

    As for bit.
    The sidewall of the ski should give the drill bit size and depth.
    If not, the general rule is 4.1mm for Carbon or metal, 3.6 for not.
    Tap if there's metal, and you can skip tapping if not. (It's always better to tap, but not required unless there's metal/titanal in the ski binding mount area.)

    There are a number of good mounting threads - this one is quite good.
    https://www.tetongravity.com/forums/...n-fucking-skis

    You have to do some reading to glean it, but it's there. You can also ask questions.

    Cheers!
    -Greg
  3. View Conversation
    Hi Greg, I was checking out your very helpful info on mounting Tyrolla Attack2 Demo bindings. Trying to mount tonight. What size drill bit do you use? US 5/16? Then Iím going to wrap duct tape 9mm down the drill head. What do you think?
Showing Visitor Messages 1 to 3 of 3
About gregorys

Basic Information

Statistics


Total Posts
Total Posts
1,227
Posts Per Day
0.42
Visitor Messages
Total Messages
3
Most Recent Message
11-29-2022 03:37 PM
General Information
Last Activity
09-21-2023 06:46 PM
Join Date
09-10-2015

1 Friend

  1. McShortyShorts  McShortyShorts is offline

    Registered User

    McShortyShorts
Showing Friends 1 to 1 of 1