Homegrown P18 jig – need to adjust for new BSL

[Sockerfarsan]

I've made this jig (well, more of a template) for my P18's (see PDF) from an old mount at 325 mm. Works great, but now my BSL is 330 mm.

How should I adjust the holes in the jig? Just +2,5 mm for and aft? What to do with the boot center mark?

[SiSt]

I´d say yes.

And just leave the center mark where it is.

Nice template! I saved a copy for use some day. I´ll adjust for a 306 bsl, but that´s no prob.

[Sockerfarsan]

Nice template! I saved a copy for use some day. I´ll adjust for a 306 bsl, but that´s no prob.

Please do! Double check the boot center mark though, may be off by 1-2 mm. Can't remember if I changed the PDF or just marked the print. Sorry...

[MnO]

You can use the template without change to any sole length if you

1. Make two lines at a distance of (325-new boot length)/2 from center line at the ski
2. Place the center line on the template on the forward line and drill the toe holes, then move to the back line and drill the heel holes. For shorter sole lengths it´s the opposite ofcourse.