FS: 10/11 ON3P Billy Goat 186cm

[harpo-the-skier]

FS: 10/11 ONSP Billy Goat 186cm

Great Condition. Currently mounted with Sollyfit Plates at 307 BSL. I would rather sell them flat without the plates but that is negotiable. Stone ground 3 times and only skied twice since the last tune.

These are the skis: http://blistergearreview.com/gear-re...lly-goat-186cm

I can post more pics if there is interest.

Asking $200 flat. Sollyfit plates, Dynafit Vertical ST bindings, Salmon Bindings, and skins negotiable.

[harpo-the-skier]

bump, all offers considered.

[harpo-the-skier]

Bump, $175 shipped, all offers considered.

[harpo-the-skier]

Pics:

[harpo-the-skier]

As you can see from the pictures, the bases and tops are both 8/10. The tails have minor top sheet chipping but the core is not exposed. There are a couple of scratches on the bases as shown in the pictures. No core shots. One scratch is right on the edge so you might want to repair it, but I wouldn't bother. Edges are pretty immaculate, not even much rust as they were just tuned in the fall.

In the pics, they are mounted with sollyfits and 914's. I would rather not sell with plates or bindings but all that is negotiable. I even have skins and tech binders that would work with this set up if you wanted them.

[harpo-the-skier]

As you can see from the pictures, the bases and tops are both 8/10. The tails have minor top sheet chipping but the core is not exposed. There are a couple of scratches on the bases as shown in the pictures. No core shots. One scratch is right on the edge so you might want to repair it, but I wouldn't bother. Edges are pretty immaculate, not even much rust as they were just tuned in the fall.

In the pics, they are mounted with sollyfits and 914's. I would rather not sell with plates or bindings but all that is negotiable. I even have skins and tech binders that would work with this set up if you wanted them.

[harpo-the-skier]

Bump. Make offer, this is a great deal on a great powder ski that is very versatile.

[harpo-the-skier]

bump......

[Kirby]

Just the one mount for the plates?

[harpo-the-skier]

No two, one for the plates and one previous unknown. The plate screw pattern is pretty wide and gives you a lot of room to work with.

[harpo-the-skier]

Bump, all offers considered.........

[thefortrees]

PM sent