• Register
  • Help

Notices

Results 1 to 3 of 3
  1. 03-09-2012, 10:51 AM #1
    tundra
    tundra is offline Registered User
    Join Date
    Dec 2008
    Posts
    9

    Mounting Marker Baron

    About ready to mount a set of Marker Barons, but I remember reading a blog (some time ago) about problems with the Duke and some of the issues concerning the center screw. The blog went on to offer some suggestions etc to minimize any potential failure of the screw, for example, tighten the screw then back off a ¼ turn, use of epoxy, torque the screw down etc. So before I start down the road of no return, I’m curious if there’s a recommended method for mounting the center screw?
    Cheers
    Reply With Quote Reply With Quote
  2. 03-09-2012, 11:04 AM #2
    hoarhey
    hoarhey is offline Registered User
    Join Date
    Nov 2003
    Location
    Wydaho
    Posts
    1,603
    here is the thread your referenced that Spats started...
    http://www.tetongravity.com/forums/s...ons?highlight=
    Aggressive in my own mind
    Reply With Quote Reply With Quote
  3. 03-09-2012, 02:42 PM #3
    tundra
    tundra is offline Registered User
    Join Date
    Dec 2008
    Posts
    9
    Hoarhey, thanks for the link. That’s exactly what I was looking for.
    Cheers
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules