Results 1 to 2 of 2
-
12-21-2004, 10:15 AM #1
Registered User
- Join Date
- Dec 2004
- Location
- Singapore
- Posts
- 7
Freeride Mount Question (not relating to shims)
getting ready to mount some Freerides and have a question about the heel elevator piece location. There are two tabs that stick up next to the rearward most binding screw hole. My question is: should the end piece of the center rail be flush with those tabs or does there need to be a certain gap there? Seems to me they would wear better if there were a small gap, then again the tabs must serve some purpose because they are there. The paper template forces a gap but the thing is crumpled out of the box and barely useable. Any experiences/opinions?
Thanks.
-
12-21-2004, 10:22 AM #2
mutant
- Join Date
- Nov 2002
- Posts
- 3,612
Get a new template faxed to you. Use that. Don't worry about gaps and taps and such.
Reply With Quote
Bookmarks