Thread: Setting forward pressure on the Dukes

has anyone done this yet? Im assuming you make the rear screw flush, but just want to double check. Any other adjustments (other than DIN) to fuss with?

I thought it was in the instructions that where included with the dukes. I can't remember off the top of my head.
Edit: Just checked and mine are flush.

this was up earlier...

http://www.tetongravity.com/forums/s...rward+pressure

i had mine mounted a couple weeks ago and the first thing the guys at the shop checked was to make sure the rear screw was flush. I would also be interested in any other details on adjustments

Mounted mine last week and instructions say flush!

Forward pressure is flush, heel din is obvious, toe din through the left toe piece, toe height, rather AFD height, straight in under the the front of the toe piece.

Well, I just reset mine and I'm wondering if it's flush with the edge of the screw or the head? It's a one click difference, any thoughts? I've lots the mounting instructions.

^^^Flush only means one thing. Anything else is counter-sunk or level with this point or...etc etc.

So the head of the screw (the surface that it would rest on if you stood it up-side down on a desk) is the surface that should be flush (even) with the surface it is screwed into.

Edit: I did check the mounting instructions to make sure it was suppose to be flush.

with most markers you want the screw to be a dime in from flush, dukes might be different though.

Dukes are FLUSH. N'uf said!

I just rechecked the manual and it is flush.