Stripped screw hole - JB Weld question?
so i'm remounting one of my skis, and one of the rear binding holes is stripped. the screw just keeps spinning. i did some searching around here, and it appears that j-b weld is the way to go. just unsure as to which is the better method?
1) do i fill the whole, let it cure, and then remount
OR
2) do i fill the whole, remount while its wet, and then let it cure with the screw set in place
which is the more secure method of ensuring i dont pull the binding? and should i use the fiberglass shavings with jb weld?
thanks.